[. . . ] Notes on the power supply lead (yellow) · When connecting this unit in combination with other stereo components, the connected car circuit's rating must be higher than the sum of each component's fuse. When no car circuits are rated high enough, connect the unit directly to the battery. The bracket and the protection collar are attached to the unit before shipping. [. . . ] The bracket and the protection collar are attached to the unit before shipping. Before mounting the unit, use the release keys to remove the bracket from the unit. Keep the release keys for future use as they are also necessary if you remove the unit from your car. Note Before installing, make sure that the catches on both sides of the bracket are bent inwards 2 mm (3/32 in). If the catches are straight or bent outwards, the unit will not be installed securely and may spring out. Be sure to connect the ground (earth) lead before connecting the amplifier. If you have a power antenna (aerial) without a relay box, connecting this unit with the supplied power supply lead may damage the antenna (aerial). notes on the control and power supply leads · The power antenna (aerial) control lead (blue) supplies +12 V DC when you turn on the tuner, or when you activate the AF (Alternative Frequency) or TA (Traffic Announcement) function. Choose the installation location carefully so that the unit will not interfere with normal driving operations. Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperature, such as in direct sunlight or near heater ducts. Use only the supplied mounting hardware for a safe and secure installation. The mounting position of the parking brake switch cord depends on your car. Consult your car dealer or your nearest Sony dealer for further details. Before installing the unit, remove the protection collar and the bracket from the unit. Insert both release keys together between the unit and the bracket until they click. Make sure that the 4 catches on the protection collar are properly engaged in the slots of the unit (-3). [. . . ] Before installing the unit, remove the protection collar and the bracket from the unit. Insert both release keys together between the unit and the bracket until they click. Make sure that the 4 catches on the protection collar are properly engaged in the slots of the unit (-3). [. . . ]